Table of Contents
Advertisement
CLOCK
TIMER START/STOP
ONE-TIME/DAILY INDICATORS
MODE BUTTON
OPERATION MODE INDICATORS -
COOLING, FAN, HEATING,
DEHUMIDIFICATION, AUTO
FAN INDICATORS -
LOW, MEDIUM, HIGH, AUTO
TIMER SET BUTTONS*
SLIDE DOWN PANEL
I
*Buttons located behind slide down panel.
PROGRAMMING TIME PERIODS — The duct free sys-
tem can be programmed to operate at desired levels. Be sure to
set the clock before programming the system.
• Increments of time are in 10 minute intervals.
• The Timer Start/Stop indicator light on the unit is on
when a time period is set. See Fig. 4.
• The remote control displays the Start/Stop time of the
time period that is closest to the current time. If the unit
is ON, "STOP" and the time period is displayed. If the
unit is OFF, "START" and the time period is displayed.
IMPORTANT: Be sure to point the remote control
toward the unit while pressing the TIMER or SET
buttons.
Setting Start/Stop Time — Timer feature is used to set unit
operation Start/Stop times. Three different time periods up to
10 hours apart and within 24 hours can be programmed using
this feature.
1. Slide down front cover of controller below ON/OFF but-
ton. See Fig. 4.
INFRARED SIGNAL TRANSMITTER WINDOW
TIMER
SET
CLEAR
UNIT
REMOTE
Fig. 4 — Remote Control
CLOCK
SENSE
beep
Fig. 5 — Location of Clock Set Button
4
TEMPERATURE SENSOR
TRANSMISSION INDICATOR
LOW BATTERY INDICATOR
UP/DOWN BUTTON
DESIRED TEMPERATURE
SENSOR ACTIVE INDICATOR
SWEEP INDICATOR
ON/OFF BUTTON
CLOCK BUTTON*
ROOM TEMPERATURE BUTTON*
DELAY BUTTON*
LOCAL SENSING BUTTON
I
TIMER
SET
CLEAR
CLOCK
SENSE
on Remote Control
Advertisement
Table of Contents
