Before The Installation - Zanussi ZGH66425XS User Manual

• Do not use water spray and steam to clean the
appliance.
• Clean the appliance with a moist soft cloth. Use
only neutral detergents. Do not use abrasive
products, abrasive cleaning pads, solvents or
metal objects.
• Do not clean the burners in the dishwasher.
SERVICE
• To repair the appliance contact the Authorised
Service Centre. Use original spare parts only.
DISPOSAL
WARNING! Risk of injury or
suffocation.
INSTALLATION
WARNING! Refer to Safety chapters.

BEFORE THE INSTALLATION

Before you install the hob, write down the
information bellow from the rating plate. The rating
plate is on the bottom of the hob.
Model .......................................
PNC .........................................
Serial number ...........................
GAS CONNECTION
WARNING! The following instructions
about installation, connection and
maintenance must be carried out by
qualified personnel in compliance with
standards and local regulations in
force.
It is necessary that the connection to the gas mains
are carried out by means of an AGB tap. Choose
fixed connections or use a flexible pipe in AGB
(stainless steel) in compliance with the regulation in
force (NBN D 51.003). If you use flexible metallic
pipes, be careful they do not come in touch with
mobile parts or they are not squeezed. Also be
careful when the hob is put together with an oven.
6
• Contact your municipal authority for information
on how to dispose of the appliance.
• Disconnect the appliance from the mains
supply.
• Cut off the mains electrical cable close to the
appliance and dispose of it.
• Flat the external gas pipes.
Make sure that the gas supply
pressure of the appliance obeys the
recommended values. The adjustable
connection is fixed to the
comprehensive ramp by means of a
threaded nut G 1/2". All the
components shown in the figure have
already been assembled in the factory.
The appliance, before leaving the
factory, has been tested in order to
give you the best results.
A B C
A. End of shaft with nut (torque force 10 ± 2 Nm)
B. Washer supplied with the appliance
C. Elbow supplied with the appliance
Liquid gas
Use the rubber pipe holder for liquid gas. Always
engage the gasket. Then continue with the gas
connection.
The flexible pipe is prepared for apply when:
• it can not get hot more than room temperature,
higher than 30°C;
• it is no longer than 1500 mm;
• it shows no throttles;
• it is not subject to traction or torsion;