Table of Contents
Advertisement
SCCG50 & SCCP50
Service Manual
16. Remove two screws holding freezing
compartment brace to cabinet, lift brace up.
17. Lift evaporator platen up and tilt back enough
for bin assembly to clear the base.
18. Remove air baffle.
19. Unplug 7 wire harness connector (at back of
bin).
20. Remove 1 screw at each corner of the base.
21. Lift bin assembly off the base.
Note: Prop evaporator assembly up. A 3' length of
Brace
3/4" PVC tubing with one end inserted into the cup
mold and the other against the base will hold it up.
The hot gas valve, fan motor, condenser and
compressor are now exposed for service.
Air Baffle
June 2008
Page 31
Chassis Shown in Front of Bin Assembly
Advertisement
Table of Contents
