Walton 01OVLP0602-V2 Instructions

01OVLP0602-V2
PLEASE READ INSTRUCTIONS CAREFULLY.
For Assistance Please Contact Customer Care on
Please retain product label and instructions for future reference
Drill
2mm bit
For ease of assembly, you must to pilot drill all
screw holes and ensure all
screw heads are countersunk.
WINTER = HIGH MOISTURE = EXPANSION
SUMMER = LOW MOISTURE = CONTRACTION
x2
*Shiplap version
shown in illustrations
This building should be erected by two people.
Tools required for installation (not supplied)
Screwdriver (cross point), Stanley knife, wood saw
and step ladders.
Before you start...
Our buildings are pre treated with a water based treatment**; this only helps to protect the product during transit and for upto 3 months against
mould. To validate your guarantee and ensure longevity of the product, it is ESSENTIAL the building is treated with a wood preserver within the rst
three months of assembly and thereafter in accordance with the manufactures recommendations.
TIMBER
As with all natural materials, timber can be a ected during various weather conditions. For the duration of heavy or extended periods of rain, swelling
of the wood panels may occur. Warping of the wood may also occur during excessive dry spells due to an interior moisture loss. Unfortunately, these
processes cannot be avoided but can be helped. It is suggested that the outdoor building is sprayed with water during extended periods of warm
sunshine and sheltered as much as possible during rain or snow.
Once your garden building has been installed it will need to be treated as soon as possible and annually to prevent the timber from deteriorating and
to waterproof it. This is required to maintain the anti-rot guarantee.
Dip Treated buildings - Require a preservative treatment to protect against rot and decay and a waterproof treatment to prevent water ingress
Pressure Treated buildings - Require a waterproof treatment to prevent water ingress
Log Cabins - Are supplied untreated and require a preservative and waterproo ng treatment.
BUILDING A BASE
When thinking about where the building and base is going to be constructed: Ensure that there will be access to all sides for maintenance work and
annual treatment.
TYPES OF BASE
- Concrete 75mm laid on top of 75mm hard-core.
- Slabs laid on 50mm of sharp sand.
Ensure the base is level and is built on rm ground, to prevent distortion. Refer to diagrams for the base dimensions, The base should be slightly
smaller than the external measurement of the building, i.e. the cladding should overlap the base, creating a run o for water. It is also recommended
that the oor be at least 25mm above the surrounding ground level to avoid ooding.
**Protim Aquatan T5 (621)**
Your building has been treated with Aquatan.
Aquatan is a water-based concentrate which is diluted with water, the building as been treated by the correct application of Aquatan solution and then
allowed to dry.
Aquatan is a decorative nish to colour the wood, which is applied industrially to timber fence panels and garden buildings.
Aquatan undiluted contains: boric acid, sodium hydroxide 32% solution, aqueos mixture of sodium dioctyl sulphosuccinat and alcohols: 2, 4,
6-trichlorophenol.
Whilst all products manufactured at Walton Garden Buildings Limited are made to the highest standards of Safety and in the case of childrens
products independently tested to EN71 level, Walton Garden Buildings Limited cannot accept responsibility for your safety whilst erecting or using
this product.
01636880514
Dimensions
Height = 1960mm
Width = 1786mm
Depth = 797mm
Front Panel QTY 1
Gable QTY 2
AI-01OVLPFP1762X1820-V2 AI-01OVLPPGL697X1919-V2
AI-01OVLPPGR697X1919-V2
Floor Panel QTY 1
AI-01OVLPFP1762X1820-V2
Roof Panel QTY 1
PI-03-0027
Felt
Iron mongery & Nail Bag Contents
Door hinge QTY 4
PI-02-1043
Pad bolt QTY 1
Turn Key QTY 2
PI-07-0035
PI-07-0034
Rear Panel QTY 1
AI-01OVLPRP1762X1919-V2
Door block - 28 x 28 x 140mm QTY 2
F2828-140MM
Eaves Framing - 28 x 28 x 1786mm QTY 1
FS2828-1786MM
Rear Fascia -12 x 60 x 1810mm QTY 1
S1260-1810MM
Side Fascia - 12 x 60 x 830mm QTY 2
S1260-830MM
Corner Trim -12 x 45 x 1918mm QTY 2
S1245-1918MM
`S1245-1818MM
10mm Felt Tacks x80
30mm Screw x80
40mm Screw x15
50mm Screw x30
Door QTY
AI-01MBDR1660X634-V1