Table of Contents
Advertisement
¢ Description of display
(1) POWER/MODE
(2) ERROR
(3) MONITOR
Switch
• For the test run start and stop.
SW1
Push
• For the pump down start and stop.
• For when check run function is activated.
SW2
Push
• For displaying the check run.
• For resetting the Automatic wiring correction memory.
SET1-1
DIP
For selecting cooling or heating during test operation.
SET1-2
DIP
For switching SW1 operation.
SET1-3
DIP
(Prohibited)
SET1-4
DIP
For outdoor unit low noise operation function.
SET2-1
DIP
For selecting outdoor unit low noise operation function.
SET2-2
DIP
(Prohibited)
SET2-3
DIP
Changing the current limit
SET2-4
DIP
Be sure to disconnect the power supply or turn off the breaker before changing the DIP switch
setting.
13-1. Setting methods
LED lamp
Green
Red
A
Red
B
Red
C
Red
D
Red
E
Red
F
Red
Function or operation method
Function or operation method
• Turns on when the power supply is ON (Including
when error occurs).
• Indicate the MODE by the number of flashes when
the installation function is active.
Flashes at high-speed when there is an error.
• Displays the location and contents of errors when
there is an error. (Refer to
for details.)
• Displays when check run is activated. (Refer to
"Check run"
on page 501 for details.)
- 499 -
"Error code"
on page 508
Factory setting
—
—
OFF
OFF
OFF (Do not change)
OFF
OFF
OFF (Do not change)
OFF
13. Function settings
Advertisement
Table of Contents
