Sanyo SAP-K71GJHA Technical & Service Manual page 69

TIMER ON button
TIMER OFF button
TIMER SET button
MODE selector button
(AUTO)
(HEAT)
(COOL)
FLAP button
NOTE
FAN SPEED selector
button
1 HR. TIMER button
(1-HOUR OFF TIMER)
ACL button
(ALL CLEAR)
ADDRESS switch
Automatic switching between cooling and heating
•
This unit automatically switches between cooling operation and heating operation according to the
difference between the room temperature and the temperature setting.
OI-396-09EG
Remote Control Unit (continued)
: The air conditioner starts at the set time.
: The air conditioner stops at the set time.
This button is used to set the time at which you wish the air
conditioner to go on or off.
Use this button to select AUTO, HEAT, DRY or COOL mode.
: When this setting is selected, the air conditioner calculates
the difference between the thermostat setting and the room
temperature and automatically switches to the ''COOL'' or
''HEAT'' mode as appropriate.
: The air conditioner makes the room warmer.
(DRY) : The air conditioner reduces the humidity in the room.
: The air conditioner makes the room cooler.
Press this button either to select to set the airflow direction to one of
the six possible positions manually, or to select the sweep function,
which moves the flap up and down automatically.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
To switch to the sweep function (
hold down the FLAP button.
: The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan speed
: When you press this button, regardless of whether the unit is
1
HR.
operating or stopping, the unit operates for one hour and
then shuts down.
Puts the remote control unit into pre-operation status. Always press
this button after replacing the batteries.
Change the address switch to prevent mixing of signals from
•
remote control units when two Sanyo air conditioners are installed
next to each other. Normally, the address switch is set to A. When
switching the address, the remote control must be changed, and the
jumper cables on the indoor unit board must be cut. For more
information, please contact the dealer where you made the
purchase.
Normally, the tabs on the remote control unit should not be bent.
•
) when in the manual ( ) mode,
9