Sanyo SAP-K71GJHA Technical & Service Manual page 66

IMPORTANT
Avoid using radio equipment
such as mobile phone near
(within 1 m of) the indoor unit.
Some radio equipment may
cause the unit to malfunction.
If the trouble occurs, dis-
connect power and restart the
air conditioner after a few
minutes.
Remote control receiver
Operation selector
ON position
OFF position
TEST position
CAUTION
OPERATION lamp
STANDBY lamp
TIMER lamp
6
Unit Display and Operation Selector
INDOOR UNIT
This section picks up infrared signals from the remote control
unit (transmitter).
This position is for operating the air conditioner with the
wireless remote control unit.
Set the selector to this position for normal operation.
Switch the selector to the OFF position if you are not going to
use the air conditioner for a few days or longer.
The OFF position does not disconnect the power. Use the main
power switch to turn off power completely.
This position is used only when servicing the air conditioner.
Do not set at the TEST position for normal operation.
This lamp lights when the system is in the continuous AUTO,
HEAT, DRY and COOL mode.
This lamp lights during the warm up period for heating and
when the system is defrosting. To keep a constant room
temperature, the air conditioner continues to supply a gentle
breeze during warm up or when the heating operation is
interrupted by the thermostat.
This lamp lights when the system is being controlled by the
timer.
Operation selector
Remote control receiver
OPERATION lamp
STANDBY lamp
TIMER lamp
OI-396-06EG