Table of Contents
Advertisement
2. Touch the Delay Start
until the display shows the desired delay time.
3. Touch the Start/Pause
the new countdown.
THE AUTOADJUST SYSTEM LOAD
DETECTION
The programme duration in the display
is referred to a medium/high load.
After touching the Start/Pause
AutoAdjust System starts the laundry load
detection:
1. The appliance detects the load in the first 30
seconds. In the programmes where FlexiTime is
available, during this phase the two dots
separating hours from minutes are blinking and
the drum rotates shortly.
2. The programme duration could be adjusted
accordingly and could increase or decrease.
After further 30 seconds, the water filling
starts.
About 20 minutes after the programme
start, the programme duration could
be adjusted again depending on the
capacity of water absorption of the
fabrics.
The AutoAdjust detection is carried
out with complete washing
programmes only and if the
programme duration has not been
reduced.
The AutoAdjust System is not available
with all programmes such as :Wool,
Rinse, Spin and programmes with
short cycles.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
When the programme is running, you can change
only some options:
1. Touch the Start/Pause
The related indicator flashes.
2. Change the options. The given information in
the display changes accordingly.
3. Touch the button Start/Pause
The washing programme continues.
20
button repeatedly
button again to start
button, the
button.
again.
CANCELLING A RUNNING PROGRAMME
1. Press the button ON/OFF to cancel the
programme and to deactivate the appliance.
2. Press the button ON/OFF again to activate the
appliance.
If the AutoAdjust System has
completed and the water filling has
already started, the new programme
starts without repeating the
AutoAdjust System. The water and
the detergent are not drained out in
order to avoid waste. The display
shows the maximum duration of the
programme, updating it about 20
minutes after the starting of the new
programme.
There is also an alternative way of cancelling:
1. Rotate the selector knob to the "Reset" position
.
2. Wait for 1 second. The display shows
Now, you can set a new washing programme.
OPENING THE DOOR - ADDING GARMENTS
If the temperature and level of the
water in the drum are too high and/or
the drum is still rotating you should not
open the door.
While a programme or the delay start operates, the
appliance door is locked. The display shows the
indicator
.
1. Touch the Start/Pause
In the display the related door lock indicator goes
off.
2. Open the appliance door. If necessary, add or
remove the items. Close the door and touch
the Start/Pause
The programme or the delay start continues.
.
button.
button.
Advertisement
Table of Contents
