Seiko Astron SSJ009J Instruction Manual page 46

7
TROUBLESHOOTING
Troubleshooting
Reception is not started even with
operation of time zone adjustment/
manual time adjustment
GPS signal
reception
GPS signals cannot be received even
by carrying out GPS signal reception
(The reception result is displayed as
"N".)
Reception is possible (reception result
display becomes "Y"), but the time and
date are not accurate (when it is
understood as a reception result after
time adjustment)
Possible causes
The charging status display is "low". (P. 11)
* The energy level can be seen by pressing and
releasing Button B.
The in-flight mode ( ) has been set. (P. 25)
* In-flight mode ( ) can be checked by pulling the
crown out to the first click.
You are in a place where GPS signals cannot be received.
A time difference from that of the current location is set.
The setting for the time difference (including DST (daylight saving time or
"summer time")) does not match the time of the current location.
Charge the watch sufficiently until the charging status is displayed
as the "middle" position or "full" position.
After relocation from a place under restriction on use of GPS signals (in an airplane, etc.), reset the in-
flight mode ( ).
(P. 16) Receive GPS signals in a place where GPS signals can be easily received.
Check the time difference (time) setting.
Reset the time difference if different from the time of the current location.
• When you are in a place where GPS signals can be easily received → How to adjust the time
zone P. 20
• When in a location with no reception → How to perform manual time difference setting (selection)
P. 23
Reset the time difference if different from the time of the current location.
→ How to perform manual time difference setting
44
ASTRON 3X22 GPS SOLAR
Solutions
middle
(selection) P. 23
Reference pages
P. 13
P. 25
P. 16
P. 20
P. 23
P. 23