Seiko Astron SSJ009J Instruction Manual page 24

4
BASIC OPERATION (HOW TO SET THE TIME/HOW TO RECEIVE GPS SIGNALS, ETC.)
How to manually adjust the time
1
Go to a place where GPS signals can
be easily received
Move to the outdoors under an open sky with good
visibility.
→ Place where GPS signals can be easily received/
Place where GPS signals cannot be received
2 Continue to press Button A (3 seconds),
and then release it when the seconds
hand moves to the 0-second position
The seconds hand will first move to the 0-second
position, then the hour and minute hands will move to
the 12-hour position.
* All three hands will point to the 12.
P. 16
* If the energy level is "low", reception will not begin
even if GPS signal reception is operated.
Expose the watch to light to charge it.
→ How to charge the watch P. 14
* When the seconds hand indicates
not begin even if GPS signal reception is operated.
Please reset the in-flight mode (
→ Reset the in-flight mode ( ). P. 25
3
Direct the watch face upward and
wait
It takes up to one minute to
complete reception.
* The reception time
depends on the reception
conditions.
Press for
3 seconds
* To cancel the reception, press Button B.
, reception will
).
22
ASTRON 3X22 GPS SOLAR
4
When the seconds hand points to
"Y" or "N", reception is completed
The reception result is displayed for 5 seconds.
When reception is successful, the time and date will be
correct.
After the seconds hand has displayed the reception
result, the hour, minute, and seconds hands will return
to their normal display.
Reception Y: Successful
result (8-second
display position)
Display
Press
Use the watch as it
State
Button B
is.
Check that the reception is successful after the watch
returns to the time display mode.
→ Check that reception was successful (reception
result display) P. 18
When "Y" is displayed but the time is not correct, the
time zone or DST (daylight saving time or "summer
time") settings may not match the current location.
Perform time difference setting (selection) manually as
necessary.
→ How to perform manual time difference setting
(selection) P. 23
* The buttons cannot be operated while the hour,
minute, and seconds hands and the date are moving.
N: Failed
(52-second
position)
When the
reception result is
displayed as "N"
→ P. 16