Frigidaire FPRU19F8WF1 Use & Care Manual page 25

4. Push firmly until the cartridge
snaps into place (you should hear a
click as the cartridge engages the
snap-in connector).
5. Press a drinking glass against the
water dispenser while checking for
any leaks at the filter housing. Any
spurts and sputters that occur as
the system purges air out of the
dispenser system are normal.
6. After filling one glass of water, con-
tinue flushing the system for about
4 minutes.
7. Press and hold WATER FILTER on
the appliance control display for 3
seconds. When the display changes
from red to green, the status has
been reset.
Pure
Air™ AF-2 Air Filter
WIth more power to clear the air, Frigid-
aire air filters banish pungent smells and
work better than baking soda.
AF-2 Air Filters:
• More powerful than baking soda
Keep your unit fresh for up to 6 months.
• Captures & Keeps Odors Away
Absorbs undesirable smells with
carbon technology.
Here are the product numbers to request
when ordering:
Pure
Air™ AF-2 Air Filter
PAULTRA2
TM
Installing or replacing the air filter
Pure
Your new Air™ AF-2 air filter is located
in the air filter cover, located in the upper
rear center of the cabinet.
Your appliance control is equipped with a
REPLACE AIR FILTER indicator to remind
you to change your filter every 6 months
to ensure optimal filtering of appliance
odors. To order your replacement filters,
please visit our online store at
Frigidaire.com, by calling toll-free at 1
(800) 372-4432, or by visiting the dealer
where you purchased your unit.
FILTER REPLACEMENT
The air filter element is held in by the
removable air filter cover which has a
stainless steel decorative plate.
1.
2. Remove the old filter and discard it.
3. Unpackage the new filter and snap
4. Reattach the air filter cover to the air
5. Press and hold REPLACE AIR
Pure
Air™
Grab the cover with your hand,
pulling until it releases from the
fixed air filter housing. The air filter
element is mounted on the back of
the cover.
it into the filter cover. The open face
(carbon media) of the filter should be
installed facing outward in the cover.
filter housing by aligning the cover
to the housing and firmly pushing it
until it snaps in place.
FILTER on the appliance control
display to reset it.
25