E-Net E-P132-X User Manual page 28

□
□ TCP socket inactive timeout imput
□
We add mechanism - "inactive timeout" to identify whether the socket active
or dead. If there is no any data transferred (send / receive) within defined
timeout period (1 to 99 minutes), then it probably a dead socket and the
socket will be closed automatically, thus a new connection can be accepted
again. The timeout period can be set by users to fit different kinds of
application.
□
□ Packet mode of serial input
□
Packet mode could be in enabled/disabled mode. If packet mode enabled,
data input from UART will be deferred until input buffer full or converter
detects 10-character packet gap and no more character arrived. The block
waiting time extended to avoid the splitting of complete packet.
□
□ Device ID
□
User assigned ID number for converter. Available ID is "0 ~ 65535".
□
□ Report device ID when connected
□
In TCP mode, if this parameter enabled every time when the socket
connected, E-P132-X TCP/IP converter will immediately report device ID in
the following formats:
Serial #1
Serial #2
Digital I/O
The total 8 bytes length, where "nnnnn" assigned 5-digit device ID by the
user; [LF] is decimal 10; [CR] is decimal 13.
□
□ Setup password
□
Administration password used to login "Controller Setup" page. It may be
empty or up to 15 long characters.
nnnnnA[LF][CR]
nnnnnB[LF][CR]
nnnnnC[LF][CR]
28