Excel Power XL8000ii Owner's Manual page 23

 Reach under the generator and
remove the black rubber seal located
below the oil drain plug.
 Place a suitable container
underneath the generator to catch
the used oil.
 Remove the oil fill cap/dipstick.
 Remove the other black rubber seal
located in the front the oil drain plug.
 Use a wrench through the hole ro
remove the oil drain plug and allow
the oil to drain completely.
 Reinstall the oil drain plug. Tighten
the plug securely.
 Reinstall the two black rubber seal
(the front one and the bottom one).
 With the generator in a level position
and refill with engine oil following the
instructions in the Checking/Adding
engine oil section previously in this
manual. For amount of engine oil
needed to refill, see Product
Specifications earlier in this manual
or the accompanying engine manual,
if applicable.
 Reinstall the oil cap/dipstick securely.
 Reinstall the left maintenance cover.
Tighten screws to secure.
NOTE:
Used engine oil should be
disposed of at an approved disposal site.
See local retailer for more information.
WARNING:
Do not change engine oil while it is hot.
Accidental contact with hot engine oil
could result in serious burns.
MAINTENANCE
Degrees Celsiusº(Outside)
Full Synthetic 5W-30
Degrees Fahrenheitº(Outside)
23