Electrical Connection And Safety - Bush CTFS60DFCB Instruction Manual

Installing your combined cooker
Bringing it all together
Determining the minimum flame position
To determine the minimum position, ignite the burners
and leave them on in the minimum position. Remove
the knobs because the screws are accessible only
when the knobs are removed. With the help of a small
screwdriver, fasten or loosen the bypass screw by
around 90 degrees. When the flame has a length of at
least 4mm, the gas is well distributed. Make sure that
the flame does not die out when passing from the
maximum position to the minimum position. Create an
artificial wind with your hand towards the flame to see
if the flames are stable.
Changing the gas inlet
For some countries, the gas inlet type can be different
for NG/LPG gases. In this case, remove the current
connection components and nuts (if any) and connect
the new gas supply accordingly. In all conditions,
all components used in gas connections should be
approved by local and/or international authorities. In all
gas connections, refer to the "Assembly of gas supply
and leakage check" clause explained above.
Electrical connection and safety ( If
Available )
WARNING: The electrical connection of this
appliance should be carried out by an authorised
service person or qualified electrician, according to the
instructions in this guide and in compliance with the
current local regulations.
WARNING: THE APPLIANCE MUST BE EARTHED.
• Before connecting the appliance to the power
supply, the voltage rating of the appliance (stamped
on the appliance identification plate) must be
checked for correspondence to the available mains
supply voltage, and the mains electric wiring should
be capable of handling the appliance's power rating
(also indicated on the identification plate).
• During installation, please ensure that isolated
cables are used. An incorrect connection could
damage your appliance. If the mains cable is
damaged and needs to be replaced this should be
done by a qualified personnel.
• Do not use adaptors, multiple sockets and/or
extension leads.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Installing your combined cooker
20
• The supply cord should be kept away from hot
parts of the appliance and must not be bent or
compressed. Otherwise the cord may be damaged,
causing a short circuit.
• If the appliance is not connected to the mains with
a plug, a all-pole disconnector (with at least 3 mm
contact spacing) must be used in order to meet the
safety regulations.
• The appliance is designed for a power supply of
220-240 V~. If your supply is different, contact the
authorized service personnel or qualified electrician.
• The power cable (H05VV-F) must be of sufficent
length to be connected to the appliance.
• The fused switch must be easily accessible once the
appliance has been installed.
• Ensure all connections are adequately tightened.
• Fix the supply cable in the cable clamp and then
close the cover.
• The terminal box connection is placed on the
terminal box.
• Green/Yellow (Earth) wire to the terminal marked
"PE".
• Brown (Live) wire to the terminal marked "L".
• Blue (Neutral) wire to the terminal marked "N".
For this connection, a 'Twin and Earth 6242Y' type
cable should be used.