Table of Contents
Advertisement
Set up the network connection
Tick the TV signal mode to tune, and then select
[Start Auto Setup]
[Satellite Antenna Setup]
≥
Ensure the satellite connections are completed (p. 14)
and select the tuner mode ([Dual Tuner] / [Single
Tuner]).
Select your region
Space Tune Adjustment
Auto Setup is now complete and the TV
is ready for viewing.
If tuning has failed check the Satellite cable, RF cable,
and the network connection, and then follow the on-
screen instructions.
Note
The TV goes into Standby mode when no operation is
≥
performed for 4 hours if [Auto Standby] in the Timer
menu is set to [On] (factory setting).
≥
The TV goes into Standby mode when no signal is
received and no operation is performed for 10 minutes
if [No signal Power off] in the Timer menu is set to [On]
(factory setting).
To retune all channels
≥
[Auto Setup] in [Tuning Menu] ([Setup] menu)
To add the available TV signal mode later
≥
[Add TV Signal] in [Tuning Menu] ([Setup]
menu)
To initialise all settings
≥
[Shipping Condition] in [System Menu] ([Setup]
menu)
Watching TV
1
Turn power on
(TV)
or
(Remote Control)
≥
Mains power On / Off switch should be on.
(p. 21)
2
Select the mode
Selectable modes vary depending on the stored
≥
channels and selected country.
3
Select a channel
up
down
or
DVB and Satellite channel position begin from number
≥
1 upward. Analogue channel position numbers are in
the 0 - 99 range.
23
English
Advertisement
Table of Contents
