Connections - Panasonic Viera TH-32LHD7 Operating Instructions Manual

Connections

When connecting the speakers, be sure to use only the optional accessory speakers.
Refer to the speaker's Installation Manual for details on speaker installation.
Speakers (Optional accessories)
SPEAKERS
Terminals (R)
– AC cord fi xing
1. Open the clamper.
Clamper
Note: The power plug in the illustration may not be the type fi tted to your set.
– Cable fi xing bands
Secure any excess cables with bands as required.
Pass the attached cable
fi xing band through the
c l i p a s s h o w n i n t h e
fi gure.
1
R AUDIO L
IN
R AUDIO L VIDEO IN VIDEO OUT R AUDIO L VD HD P R /C R /R P B /C B /B Y/G
IN AV
S VIDEO IN COMPONENT/RGB IN AUDIO
SLOT 1 SLOT 2 PC IN SERIAL
AC cord connection (see page 12)
2. I n s e r t t h e A C c o r d
and close the clamper
securely.
AC cord
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
VIDEO OUT
VIDEO IN
R AUDIO L
AV COMPONENT/RGB IN
S VIDEO IN
SLOT1
SPEAKERS
Terminals (L)
3. Slide up the clamper and fi x
the AC cord plug securely.
When loosen
the clamper:
To tighten:
Pull
Optional Terminal Board insert Slots (covered)
VD HD P /C /R P /C /B Y/G
R R B B
PC
SLOT2
From EXTERNAL
monitor terminal on
Computer (see page 10)
1
2
2
4. Insert the point of the
fixed clamper into the
small hole on the lower
To loosen:
Push the catch
Pull
AUDIO
IN SERIAL
From SERIAL Terminal
on Computer
(see page 11)
1
r i g h t o f
t h e b a c k
c o v e r a s
necessary.
9