NEC MultiSync LCD1980SXi-BK User Manual page 54

Appendix
The color temperature and tone that were set up with the downloaded
application software are reflected.
Tag7
Sharpness Press "+" or "-" to adjust. This is a digital capability for keeping a
crisp image at all signal timings. It continuously adjusts to maintain a
distinct or soft image as preferred, and is set independently according
to different timings.
Expansion Mode Sets the zoom method.
FULL: The image is expanded to 1280 x 1024, regardless of the
resolution.
ASPECT: The image is expanded without changing the aspect ratio.
OFF: The image is not expanded.
CUSTOM1: Zoom with center fixed. The image is expanded from the
rate of 1.00 to 3.00 times individually for horizontal (H.EXPANSION)
and vertical (V.EXPANSION) direction by 0.01 step.
CUSTOM2: Zoom with top left corner fixed. The image is expanded
from the rate of 1.00 to 3.00 times individually for horizontal
(H.EXPANSION) and vertical (V.EXPANSION) direction by 0.01 step.
Video Detect Selects the method of video detection when more than one computer
is connected. Press "+" or "-" to select.
FIRST DETECT: The video input has to be switched to "FIRST DETECT"
mode. When current video input signal is not present, then the
monitor searches for a video signal from the other video input port. If
the video signal is present in the other port, then the monitor switches
the video source input port to the newfound video source automati-
cally. The monitor will not look for other video signals while the
current video source is present.
LAST DETECT: The video input has to be switched to the "LAST
DETECT" mode. When the monitor is displaying a signal from the
current source and a new secondary source is supplied to the monitor,
then the monitor will automatically switch to the new video source.
When current video input signal is not present, then the monitor
searches for a video signal from the other video input port. If the
video signal is present in the other port, then the monitor switches the
video source input port to the new found video source automatically.
NONE: The Monitor will not search the other video input port unless
the monitor is turned on.
DVI Selection This function selects the DVI input mode (Input 1). When the DVI
selection has been changed, you must restart your computer. Press
"+" or "-" to select.
AUTO: By using the DVI-D to DVI-D cable, the DVI SELECTION is
DIGITAL. By using the D-SUB to DVI-A cable, the DVI SELECTION is
ANALOG.
DIGITAL: DVI digital input is available.
ANALOG: DVI analog input is available.
Off Timer Monitor will automatically power-down when the end user has
selected a pre-determined amount of time.
Language OSM control menus are available in seven languages. Press "+" or
"-" to select.
LCD1980SXimanual060704.p65
–continued
52
52 6/10/04, 9:28 AM