NEC MultiSync LCD1980SXi-BK User Manual page 10

Controls
Use left/Right Menu to center the image on the screen. If the H.Size or V.Size
is wrongly calibrated, the result would look like the left drawing. The image
should be homogeneous.
Wrong
FINE (Analog input only)
Improves focus, clarity and image stability by increasing or decreasing this setting.
If the "Auto Adjust function" and the "H.Size" function do not give you a
satisfactory picture setting, a fine tuning can be performed using the "Fine"
function. It improves focus, clarity and image stability by increasing or decreas-
ing this setting.
For this a Moiré test pattern could be used. If the Fine value is wrongly
calibrated, the result would look like on the left drawing. The image should be
homogeneous.
AccuColor ® Control Systems
Seven color presets select the desired color setting (sRGB, NATIVE and
PROGRAMMABLE color presets are standard and cannot be changed). Color
temperature increases or decreases, in each preset. R,Y,G,C,B,M,S: Increases
or decreases Red, Yellow, Green, Cyan, Blue, Magenta and Saturation
depending upon which is selected. The change in color will appear on screen
and the direction (increase or decrease) will be shown by the color bars.
NATIVE: Original color presented by the LCD panel that is unadjustable.
PROGRAMMABLE: The colour temperature and tone that were set up with the
downloaded application software are reflected.
NOTE: To reset a poor image setting, turn on the monitor by using the front
power button while holding "EXIT" and "SELECT" buttons at the sametime.
Tools 1
SHARPNESS: This function uses digital technology to keep a crisp image at
any timing. Sharpness is independent from other setting and can be adjusted
continuously to get a distinct or soft image.
EXPANSION MODE: Sets the zoom method.
FULL: The image is expanded to 1280 x 1024, regardless of the resolution.
ASPECT: The image is expanded without changing the aspect ratio.
OFF: The image is not expanded.
CUSTOM1: Zoom with center fixed. The image is expanded from the rate
of 1.00 to 3.00 times individually for horizontal (H.EXPANSION) and
vertical (V.EXPANSION) direction by 0.01 step.
LCD1980SXimanual060704.p65
–continued
Wrong
8
8
Correct
Correct
6/10/04, 9:28 AM