Table of Contents
Advertisement
en Troubleshooting
Fault
Loud noises during
the spin cycle.
Banging noises, rat-
tling in the drain
pump.
Slurping, rhythmical
suction noise.
Creasing.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
48
Cause and troubleshooting
Secure the appliance feet.
▶
→ "Aligning the appliance", Page 15
Transit bolts have not been removed.
→ "Removing the transit bolts", Page 13.
▶
Foreign bodies have got into the drain pump.
→ "Cleaning the drain pump", Page 38
▶
The drain pump is active, the detergent solution is
pumped out.
Not a fault – normal operating noise.
▶
The spin speed is too high.
The next time you run a wash cycle, set a lower
▶
spin speed.
The load is too large.
The next time you run a wash cycle, reduce the
▶
amount of laundry being loaded.
Unsuitable programme for the type of fabric.
Select the programmes that are suitable for the
▶
type of fabric.
Too much detergent/fabric softener in the detergent
drawer.
When dosing liquid detergent and fabric softener,
▶
observe the marking in the detergent drawer and
do not dose above this.
A low spin speed is selected.
The next time you run a wash cycle, set a higher
▶
spin speed.
Start the Centrifugering programme.
▶
is activated.
Select the programmes that are suitable for the
▶
type of fabric.
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Advertisement
Table of Contents
