AEG LWR7496O4B User Manual page 18

18 www.aeg.com
7.3 Introduction
The options/functions are
not selectable with all
washing programmes.
Check the compatibility
between options/functions
and washing programmes in
the "Programme Chart". An
option/function can exclude
another one, in this case the
appliance doesn't allow you
to set the incompatible
options/functions together.
Make sure the screen and
touch buttons are always
clean and dry.
7.4 Finish In
Set this option as last after
programme and other
options selection, otherwise
it can be cancelled if you
change some setting.
This option allows choosing the time
within which a programme should
terminate. The programme end can be
postponed by one 1 hour every button
touch until 24 hours maximum.
The display shows the normal
programme duration alternatively with
the set programme end time (expressed
in hours 0h). The minimum selectable
time corresponds to rounded up hour of
the maximum duration of a programme
(e.g. if the cycle duration lasts 3:15
hours, the minimum selectable time will
be 4h).
After programme start, the door is locked
and the appliance starts the ProSense
phase. When load estimation ends, on
the display the icon of running phase
blinks and the time digit counts down in
steps of one hour and in steps of 1
minute during the last hour.
7.5 Start / Pause
Touch the Start / Pause
start, pause the appliance or interrupt a
running programme.
7.6 Time Save
With this option you can decrease the
programme duration.
• If your laundry is normally or lightly
• In case of smaller load, touch this
The led of the button is on and the
display shows the set programme
duration.
7.7 Temperature
When you select a washing programme,
the appliance automatically proposes a
default temperature.
Touch this button repeatedly until the
desired temperature value appears on
the display.
When the display shows the indicators
the water.
7.8 Spin
When you set a programme, the
appliance automatically selects the
default spin speed.
Touch this button repeatedly to:
• Change the spin speed.
• Activate the Rinse Hold option .
button to
soiled, it may be advisable to shorten
the washing programme. Touch this
button once to decrease the duration.
button twice to set an extra quick
programme.
In this case, the temperature 95°C is
not selectable.
This option can also be used
to shorten the steam mode
duration.
and , the appliance does not heat
The display shows only
the spin speeds available
for the set programme.
The water of the last rinse is not
drained out to prevent the fabrics from
creasing. The washing programme
ends with water in the drum and the
final spin phase is not performed.
The display shows the indicator
The drum turns regularly to reduce
creasing.
.