Table of Contents
Advertisement
PANO (PANORAMA)
This control extends the front stereo image to include
the surround speakers for an exciting "wraparound"
effect with side-wall imaging. It is particularly effective
for recordings which have strong left- or right-channel
elements in the mix, as these are detected and
accentuated by the Panorama process.
C WIDT (Center Width)
This control allows center-channel sounds to be
positioned between the center speaker and the left/right
speakers over a range of eight steps. Step "3" uses a
combination of all three front speakers to give the best
vocal imaging and most seamless soundstage
presentation, and is recommended for most recordings.
Step "0" places all center sound in the center speaker.
Step "7" places all center sound equally in the left/right
speakers, just as in conventional stereo.
DIMEN (DIMENSION)
This control allows the user to gradually adjust the
sound field either towards the front or the rear. This can
be useful to help achieve the desired balance from all
the speakers with certain recordings that may contain
either too much or too little spatial effect. Step "0" is the
recommended setting, which has no effect on the
sound. Steps 1, 2, and 3 gradually move the sound
forward, and steps –1, –2, and –3 move the sound
towards the surrounds.
Sound Level
You can set the sound level of the desired channel.
1. Press LEVEL/DELAY on the remote control.
The level indicator will appear in the Display Window.
2. Press
/
to select a desired speaker to set.
Each time you press the
in the following order;
FL (Front Left) → C (Center) → FR (Front Right) →
SR (Surround Right) → SL (Surround Left) →
SW (Subwoofer) → FL (Front Left) ...
3. Press
/
to adjust the sound level of the selected
channel. (-6dB ~ +6dB)
4. Repeat step 2-3 and adjust the sound level of the
other channels.
5. If setting is complete, press LEVEL/DELAY.
18
Test Tone
This function allows you to can easily adjust the sound
balance of the speakers from the listener's position.
1. Select the test tone mode by pressing TEST TONE.
2. You can adjust the sound level while the test tone is
3. If setting is complete, press TEST TONE.
XTS/XTS pro
Each time you press XTS pro the setting changes in
the following order.
XTS-PRO ON → XTS ON → NORMAL
/
button, it is changed
A hiss noise comes out for 2 seconds from each
speakers in the following order;
FL (Front Left) → C (Center) → FR (Front Right) →
SR (Surround Right) → SL (Surround Left) →
SW (Subwoofer) → FL (Front Left) ...
operating. First press LEVEL/DELAY then press the
/
buttons, so that the sound level from all the
speakers is same from the listener's position.
• During the test tone, if you adjust the sound level, it will
be paused in the current speaker channel.
XTS-PRO ON
The unique sound quality of the LG Technology
creates the optimum sound for you to play the
perfect playback of the original sound and to feel the
living sound source.
XTS ON
When playing the movie with the weak bass sound
relatively to the general music, it enforces the sense
of sound at woofer for you to satisfy with.
In the mode of 2 CH BYPASS, It creates the high
display effect by playing the sound source via the
rear speakers same as the front speakers.
Note:
The XTS mode is temporarily disabled when
changing from 2.1 CH to 5.1 CH and it is enabled
when changing it to 2.1 CH.
NORMAL
XTS-Pro and XTS mode tune off
Advertisement
Table of Contents
