UNI-T UDP3000S-D User Manual page 21

UDP3305S Series Programmable DC Power Supply User Manual
Delayer Parameter Setting
The interface of delayer is as follows:
To set the delayer parameters manually:
Press "Basic parameter" key to enter the setting interface. Users can edit the starting group number, the required
number of output groups (maximum 2048 groups), the number of cycles (maximum 99999 times), and conditions
for terminating the output state and stopping the delayer. Set parameters for each group: Set voltage, current, and
time parameters for each group based on the required number of output groups.
To set the list mode parameters using template:
Press "Auto generation" to open the template editing menu.
1. Press "Type" to select the desired template;
2. Press "Start group" to edit the start group number;
3. Press "Total points" to set the number of points required for this delay (maximum 2048 points);
4. Press "Mode" or "Time" to set parameters for each template. Press "Mode" to select 01 code (off/on cycle) or
10 code (on/off cycle). Press "Time" to edit time base value, step value, open time and close time, etc. (the menu
varies according to different templates).
5. After all parameters are set, press "Generate" to complete the delayer template output setting.
6. Press "Enable", the delayer will control the automatic output of the corresponding channel.
Templates