VMAC will not be held responsible for any liability, consequential damages, injuries, loss or damage to individuals or to equipment as a result of the failure of anyone to properly adhere to the procedures set out in this manual or standard safety practices.
Warranty registration for VMAC systems can be completed online or by filling in the form at the back of each system installation manual. Warranty registration must be completed and sent to VMAC at the time the system is put into service for any subsequent warranty claim to be considered valid.
Page 7
If requested, failed parts must be returned to VMAC for evaluation. 4) Dealers may login to the VMAC website to view the "VMAC Labour Time Guide" (under “Agreements”) to see the allowable warranty labour times. 5) Warranty invoices must include the Service Ticket number, VMAC System ID#, hours on the compressor, and a detailed description of the work performed.
Please contact VMAC for replacement hoses and further information. Ordering Parts To order parts, contact a VMAC dealer. The dealer will ask for the VMAC serial number, part number, description and quantity. Locate the nearest dealer online at www.vmacair.com/dealer-locator or call 1-877-912-6605.
Page 9
All fasteners must be torqued to specifications. Use manufacturers’ torque values for OEM fasteners. The torque values supplied in Table 1 are intended for VMAC supplied components, or for use as a guide in the absence of a torque value provided by an OEM.
Do not use a test light to probe for power on vehicle circuits, the increased current draw of the test light may damage components. • VMAC recommends using only sealed crimp and solder butt connectors for all electrical connections. •...
Use only genuine VMAC parts to maintain the system. Genuine VMAC parts are designed to work with the high pressure and heat generated by the compressor. Substituting genuine VMAC parts may void the warranty and could cause equipment damage, injury, or death.
*Resistance should be less than 30 Ω when the park brake is engaged. ☐ *Resistance should be open circuit when the park brake is released. ☐ Shut down the engine. VMAC - Vehicle Mounted Air Compressors VMAC Technical Support: 888-241-2289 VMAC Knowledge Base: kb.vmacair.com...
Page 14
Secure the UIM module and gateway harness up and out of the way of the pedals, steering column, and the park brake mechanism. If the blue wire running from the 8 pin connector on the VMAC throttle control is currently connected to the green wire on the gear selector: Option 1 ☐...
☐ Engage the Park Brake. ☐ Start the vehicle. ☐ Turn the VMAC system on. *The VMAC system should run normally. *Release the park brake. ☐ *The the compressor clutch should disengage and engine speed should reduce to OEM idle.
Need help?
Do you have a question about the A700327 and is the answer not in the manual?
Questions and answers