Absolute EP-720-04M User Manual page 15

Laser beard shaper - for men
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 12
1. Ensure your skin is clean with no oily products and completely dry
before to proceed.
2. For the first time; you should test the compatibility of the device with
your skin. The purpose of the test is to find out whether your skin reacts
naturally well to laser treatment.
3. Choose a concealed area of your body, such as a thigh.
4. Do not remove hair using an epilator/tweezers/wax before the
treatment. It is better if the hair is visible.
5. If the hair is long, it should be trimmed to 1-2 mm, using scissors or a
hair trimmer.
6. Use the power button and turn on the device. The
will flash. Aim the Laser-beam opening to the treated hair.
7. Attach the Laser-beam opening to your skin. The laser automatically will
operate and will treat the hair for 1 second.
8. When you place the laser beam window against your skin, the device
beeps and the
green
sensation of heat on the affected area for the second time needed for
treatment. If you remove the laser beam window from the area to be
treated too early, the device will alert you by emitting vibrations.
9. After 5 minutes check the treated area.
10. If the treated spot appears red or irritated, please wait 24 hours and
repeat the test.
11. Otherwise consult your doctor.
12. After you made sure that your skin reacts well to laser, you can use it as follows:
• Turn the device on in the same manner as for the test.
• Place the device against the skin on the hair to be treated and treat the hair the
same manner as for the test.
• Always turn off the device after use.
13. After the 8 weeks treatment, the follicule will be weakened and fall down. In can
take some times, depending on each body and skin (from 3 to 14 days). Between 2
treatments, if you feel unconfortable with the remaining hair, do not hesitate to shave
or epilate them. It will not affect the laser efficiency and result of the treatment.
14. Use the device once or twice a week for 8 to 12 weeks. In order to optimize your
treatment, we recommend that you perform three laser shots on the hair to be treated
continuously.
15. Using the device may cause slight tingling sensation. This means that the beam
"hit" the follicle. However, if the use of the device is accompanied by pain, a burning
sensation, a burn, swelling of the skin, or any other unusual reaction, stop using the
device. Once again, do not hesitate to shave or epilate the hair. It will not affect the
laser efficiency and result of the treatment.
16. Then make spot repairs or additional treatments if necessary. When the device is used
according to the instructions in this manual, it is a device for personal use that provides
permanent hair removal. The results vary among people and depend on which areas
of the body are treated and how well the treatment instructions are followed.
/
red
LED flashes, and you will feel a slight
15
green
indicator light

Advertisement

Table of Contents
loading

Table of Contents