Daily Use - Washing & Drying - AEG LWR7175M2B User Manual

12. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
12.1 Complete wash&dry
programmes
Non-automatic wash&dry
programmes
In some washing programmes, you can
combine Wash and Dry mode for running
a complete wash&dry programme.
Proceed as follows:
1. After loading laundry and detergent,
press the On/Off button for some
seconds to activate the appliance.
2. Load the laundry one item at a time.
3. Put the detergent and the additives in
the appropriate compartment.
4. Turn the programme dial to the
washing programme. The display
shows the default temperature and
spin. If necessary, change them
according to your laundry. The
display also shows the maximum
recommended load for washing
phase.
5. Set the desired options, if there are
available.
6. Touch the MODE button once to
activate also the drying function. The
Wash and Dry indicators come on.
The indicators
appear on the display. The display
also shows the maximum
recommended load for a washing
and drying programme (e.g. 5.0 kg
for cottons).
7. Now, you can choose an automatic
drying level or a specific timed
drying.
12.2 Washing and Drying -
Automatic levels
1. Tap on the Auto Drying button
repeatedly until the display shows the
and
required dryness level. The indicators
in the display illuminate accordingly:
a. Iron dry: for cotton
items;
b. Cupboard dry: for
cotton and synthetic items;
c. Extra dry: for cotton
items.
The time value on the display is the
duration of both cycles washing and
drying, calculated on a default load
size.
To have a good drying by
using less energy and in a
shorter time, the appliance
does not let you set a too
low spin speed for the items
to be washed and dried.
2. Touch button Start/Pause to start the
programme. The PROSENSE
estimation starts.
In the display the door locked
indicator goes on, the indicator of the
running phase starts flashing.
The display also shows the remaining
programme time.
12.3 Washing and Timed
Drying
1. Tap on the button Time Drying
repeatedly to set the desired time
value (see the "Timed drying" table
the "Programmes" chapter). The
drying level indicator goes off and the
indicator comes on.
Each time you tap on this button the time
value increases by 5 minutes. The
display shows the set new time value.
2. Touch the Start/Pause to start the
programme. The ProSense
estimation starts.
In the display the door locked
indicator comes on and the indicator of
the running phase starts flashing.
The display also shows the remaining
programme time.
ENGLISH 33