Table of Contents
Advertisement
The appliance empties
the water out
automatically after 18
hours approximately.
• Activate the Quiet option.
The intermediate and the final
spinning phases are suppressed and
the programme ends with water in the
drum. This helps to reduce creasing.
The display shows the indicator
The door stays locked. The drum
turns regularly to reduce creasing.
You must drain the water to unlock
the door.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are
available. In some programmes the
rinses are performed with more water.
If you touch the Start/Pause button,
the appliance performs the only
draining phase.
The appliance empties
the water out
automatically after 18
hours approximately.
• Activate the drain-only option
(Skipping the wash, rinse and spin
phases): Only Drain.
The appliance performs the only
draining phase of the selected
washing programme.
The display shows the indicator
(cold), and the indicator
spin) and the indicator
• Activate the spin-only option
(Skipping the wash and rinse
phases): Only Spin.
Before setting this option,
select a suitable washing
programme for the
garments. The appliance
will performs the most
fitting spin cycle for your
garments care (e.g. For
synthetics items, first
select the Synthetics
washing programme and
then the Only Spin
option).
The appliance performs only the
spinning phase of the selected
washing programme.
The display shows the indicator
(cold), the phase indicator
spin speed.
7.5 Options
Press this button repeatedly to activate
.
one of the two options.
The relevant indicator goes on in the
display.
• Stains
Select this option to add an anti-stain
phase to a programme in order to
treat heavily soiled or stained laundry
with stain remover.
Pour the stain remover into
compartment
will be added in the appropriate phase
of the washing programme.
• Prewash
Use this option to add a pre-wash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust , mud and other
(no
solid particles.
.
7.6 Delay Start
With this option you can delay the start of
a programme in a more convenient time.
Tap on the button repeatedly to set the
required delay. The time increases by
steps of 30 minutes up to 90' and from 2
hours up to 20 h.
After starting the cycle by the means of
the Start/Pause button, the display
. The stain remover
This option is not
available with a
temperature lower than
40 °C.
The options can increase the
programme duration.
These two options cannot be
set together.
ENGLISH
17
and the
Advertisement
Table of Contents
