Sharp VC-A10 Service Manual page 80

VC-A10/A10S/A500
VC-A50/A50S/A50SB
VC-A60/A75/A80S
FRONT PANEL PARTS(VC-A10/A10S/A50/A50S/A50SB/A60/A75/A80S)
F
E
D
C
B
A
1
PRECAUTION ON FRONT PANEL SET-UP
Cassette cover
open lever
500-7
500
500-10
500-1
500-6
2 3
Cassette housing
Cassette cover
open lever
Before attaching the front
panel in position, make
sure that the cassette cover
open lever is in its right
place (lower-most). If it is
out of position, push it down
with a finger.
500-3
500-2
4
Front panel
Cassette cover
Cassette cover
open lever
About 45°
Keep the cassette over about Do not mount the front
45° open and make sure that panel with the cassette
the cassette cover open le- cover tilted too open.
ver is between the front panel Otherwise the cassette
and the cassette cover. Now cover might wrongly run
fix the front panel in place. on the cassette housing.
80
500-12
500-11
501
502
5 6
Cassette cover
3
4
1
2
5
Removing the cassette compartment cover.
1 Open the cassette compartment cover
fully.
2 Remove the center positioner.
3 Slide the cover to the right.
4 Slightly bend the cover.
5 Draw out the left-side rod.