Table of Contents
Advertisement
NOTE
1.
In case of the Idler Arm installation, install as the circled
section of Fig. 4-10-B.
2.
In case of the Idler Arm Spring installation, install as the
circled section of Fig. 4-10-C.
3.
In case of the Chassis Spring installation, install as the
circled section of Fig. 4-10-D.
Idler Arm
Main Chassis Ass'y
Main Chassis Ass'y
4-11: FEED MOTOR (Refer to Fig. 4-11-A)
Remove the 2 screws 1.
1.
2.
Remove the Feed Motor.
3.
Remove the Motor Gear.
1-6
DISASSEMBLY INSTRUCTIONS
Main Chassis Ass'y
Fig. 4-10-B
Idler Arm Spring
Fig. 4-10-C
Chassis Spring
Fig. 4-10-D
Motor Gear
Feed Motor
• Screw Torque: 1 ± 0.5kgf•cm
NOTE
1.
In case of the Motor Gear installation, check if the value
of the Fig. 4-11-B is correct.
2.
When installing the Feed Motor, check if the cable is
positioned as Fig. 4-11-C.
Motor Gear
Feed Motor
Safety surface for pressing
of the insert.
Main Chassis Ass'y
Pass the cable
between 2 pins.
1 1
Main Chassis Ass'y
Fig. 4-11-A
6.1 ± 0.1mm
Fig. 4-11-B
Feed Motor
Fig. 4-11-C
Advertisement
Table of Contents
