Technical Data - Zanussi ZDPB274B User Manual

The tumble dryer does not heat up. The laundry
inside is cold and wet.
The filter is clogged. The emergency heater shut-
down.
Display shows 1 min or few minutes to the cycle
end for longer time. The laundry inside is cold
and wet.
The filter is clogged. The emergency heater shut-
down.
The display shows Err.
The display shows an Error code (e.g. E51).
1) After maximum 6 hours, the programme ends automatically.
2) It can happen that some area remains humid when drying big items (e.g. bed sheets ).
If the drying results are not satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the appliance.
• The drum is dirty.
• Incorrect setting of the conductivity sensor
( See chapter "Settings - Adjustment of the

TECHNICAL DATA

Height x Width x Depth
Max. depth with the appliance door open
Max. width with the appliance door open
Adjustable height
Drum volume
Maximum load volume
Voltage
Frequency
Sound power level
Total power
Energy efficiency class
18
Problem Possible solution
Clean the filter (see chapter CARE AND
CLEANING).
Clean the filter (see chapter CARE AND
CLEANING).
If you want to set a new programme, deactivate
and activate the appliance.
Make sure that the options are applicable to the
programme.
Deactivate and activate the appliance. Start a
new programme. If the problem occurs again,
contact the Service.
remaining laundry moisture degree " for better
setting).
• The airflow slots are clogged.
• Room temperature is too low or too high
( optimal room temperature 18°C to 25°C )
850 x 596 x 555 mm (maximal 583 mm)
1019 mm
945 mm
850 mm (+ 15 mm - feet regulation)
104 l
7 kg
230 V
50 Hz
67 dB
2800 W
B