Project Source 05535028 Installation Instructions Manual page 6

ASSEMBLY INSTRUCTIONS
1. An ARCH is the assembly of: one center #11, two
corners #12,two posts #7 or #8 Jarch sfiffener #10.
Assemble all arches on the ground making sure that you
follow the positions shown. Caution: Set the first arch
with two # 8 post 2 holes to secure the # 9 and #14
diagonals. Connect the base of the posts of the first arch
with the base of the posts of the second arch with two #4
swedge brace and secure the# 9 and # 14 at the base of
the posts of the second arch. Lift the first arch and bolt
the diagonals to the posts of the first arch. Lift the second
arch and secure it to the first one by putting in place the
#4 swedge braces. To assemble the other arch, secure
the base of the post of the last arch lifted with the base of
the post of the next arch. Lift it and secure them by
putting in place the proper brace. Caution: Always place
the #5 female braces between the second and third arch.
Important: All the wing nuts must be tightened and placed
inside the shelter in order not to touch the cover.
Hardware Used
1
1/4 x 1-3/4 Car Bolt
2
1/4 x 2-1/2 Car Bolt
2. Before putting the cover on, set the frame where you
want it, adjust the base width and set the frame square
measuring as shown (Fig. B). The two measurements
must be the same. Caution: If the structure is not
perfectly square, the cover will be difficult to install and
it could be damaged during the installation.
1
x 14
x 15
2
Page 6