Back Panel Doors, Buttons And Connections - 3Com PalmPilot Professional Handbook

Back Panel Doors, Buttons and Connections

Memory door. The memory door covers the memory
circuitry of your PalmPilot. The memory door may be
removed to allow the installation of memory expansion units
available from your dealer (or 3Com). However, you will
never have to remove or replace the memory door in the
normal use of your PalmPilot.
Reset button. The actual reset button is located deep within
PalmPilot, and can be activated by pushing the end of an
unfolded paper clip (or similar blunt object) into the hole.
Never press the reset button with a sharp object, such as a pin.
Under normal use, you should never have to use the reset
button. Refer to the section entitled "Resetting the PalmPilot
Connected Organizer" in Chapter 12: Reference for information
about how to use the reset button.
Battery door. The battery door covers the batteries that
power your PalmPilot. The following section explains how to
remove the battery door to install the batteries.
Serial port. The serial port fits into the connector of the
PalmPilot Cradle. As you use your PalmPilot, you should
make sure that the connection surface of the serial port
remains clean and clear of debris.
Chapter 1: The PalmPilot
Memory door
Reset button
Battery door
Serial port
™
Connected Organizer and its Controls
™
page
7