Table of Contents
Advertisement
Before Calling for Service
Problem
Oven light not
Check for loose bulb.
working
Check for burned out bulb; replace
with 40 watt appliance bulb.
Oven not
Confirm range is plugged in.
heating
Check for tripped circuit breaker.
Oven door will
Wait for oven to cool. Door latch will
not open
release automatically. Unlatch door
when cool.
Rangetop gets
This is normal.
warm during
use
Oven
Store bought oven thermometers do
temperature is
not measure oven temperature
not accurate
accurately. A digital thermometer is
necessary to calibrate oven.
Check for blocked heat vents.
Aluminum foil alters oven
temperature.
Confirm correct utensil is used for
cooking.
Oven element
This is normal when baking or
cycles on and
roasting.
off
Self-clean
Confirm oven door latch is closed.
cycle not
working
Common Questions
Should the oven maintain a constant temperature on an
oven thermometer?
• To maintain a temperature for baking, the oven
cycles on and off. The temperature may vary up to
25°F higher or lower than the oven temperature set
on the control.
Is there a problem if the oven smokes the first few times it
is turned on?
• Some minor smoking is normal when using oven
first few times.
Should there be an odor or smoke while self-cleaning the
oven?
• There may be some smoke and odor during the first
few cleaning cycles. If there is excessive smoke or
odor, too much soil remains in the bottom of the
oven. If the oven smokes excessively, turn off the
oven, wait for the oven to cool and wipe away the
excess soil. Reset the clean cycle.
Check
26
Adjusting Thermostat
Oven temperature has been factory calibrated and tested.
In unlikely event that oven consistently overcooks or
undercooks food, make following adjustment.
1. Push BAKE pad.
2. Push
or
until an oven temperature greater than
500°F displays.
3. Immediately push and hold BAKE pad until "00"
displays, approximately 5 seconds.
4. To decrease oven temperature (for a cooler oven),
Push
or
until negative numbers appear. Oven
can be adjusted from -05° to -35° lower. To avoid over
adjusting oven move temperature -5° each time.
5. To increase oven temperature (for a warmer oven),
Push
or
until positive numbers appear. Oven can
be adjusted from 5° to 35° higher. To avoid over
adjusting oven move temperature 5° each time.
6. Push OVEN CANCEL button. Temperature
adjustment will be retained even through a power
failure.
Service Tones
Electronic range control is equipped with a self diagnostic
system. Self diagnostic system will alert you if there is a
error or problem in the control. If electronic range control
sounds a series of short, rapid beeps for over 16 seconds
and display shows a F-code, record the F-code shown.
Disconnect electrical supply to range and contact an
authorized servicer.
Some F-codes can be cleared by touching CANCEL or
disconnecting power to the range. If code continues to
reoccur call an authorized servicer
• Pressing cancel button may temporarily cancel F-
code and allow a cooking function to be reset.
However, failure code will continue to occur. An
authorized servicer must be contacted to check
range
Advertisement
Table of Contents
