Jimmy Styks INFLATABLE WATER MAT Owner's Manual page 4

1.
NEVER USE THE VALVE WRENCH WHEN WATER MAT IS PRESSURIZED
Occasionally, the valve on your inflatable WATER PAT may become loose. If the valve
flange freely spins when opening the valve cover or you detect air leaking from the
valve area, tightening may be required. Using the included valve wrench, tighten valve
in a clockwise motion until hand tight.
IMPORTANT NOTED: Always check if the valve is sealed completely, or using the
VALVE WRENCH to slightly tighten up before inflating the product.
CAUTION : Do not have your face/eyes over the vent when deflating.
2.
(Two-way air flow position for deflation)
The valve has two positions. The first is two-way which is for deflation only. The second is
one-way which is for inflation only. To switch between positions just push the center of the
valve stem down once. To switch again, push the center of the valve stem once more.
6
OPEN
CLOSE
(one-way air flow position for inflation)
3.
To inflate, unscrew the valve cap, turn and push the
center of the valve stem to switch the valve back to
one-way air flow position.
4.
O U T
ATTAHED THE HOSE TO
THE BUMP HANDLE
≥
EASY
MARKED "OUT" WHICH
≥
HIGH PERSSURE
IS FOR INFLATION
(Recommend: 10-15 PSI)
SCAN THE QR CODE
READ BEFORE SETUP
ATTAHED THE HOSE TO
THE BUMP HANDLE
≥
FAST
MARKED "IN" WHICH IS
≥
HIGH CAPACITY
FOR DEFLATION
(Recommend:0-10 PSI)
IN
7