Philips EasyKey 7000 Series User Manual page 9

Put the compressed spring and
5
square shaft on the inside escutcheon
accordingly.
Open the upper
7
decorative cover and the
battery cover, mount,
and tighten the M6
anchor screws to secure
the inside escutcheon.
Attention
After installing the strike plate, please test to see if the door opens and closes smoothly.
Insert the escutcheon connecting cables
6
and mortise connecting cables into the
corresponding socket of the inside escutcheon,
then connect the antenna, and align the
square shaft hole on the inside escutcheon
against the rotary hole on the mortise, so that
the inside escutcheon is closely attached to the
inner surface of the door.
Mortise
connecting
cable
Connecting
cable of outside
escutcheon
Antenna
Attention
Be sure to put the escutcheon connecting cables
and the mortise connecting cables into the slot on
both sides of the square shaft, and hide the extra
cables in the door hole or inside escutcheon.
Install the battery and
8
put the battery cover
back, then mount the
upper decorative cover
and install the strike
plate to finish the
assembly.
Socket of mortise
connecting cable
Socket of
escutcheon
connecting cable
Check the rotary knob,
9
the mechanical key, and
whether each part is
connected and assembly
in good condition.
7