Download Print this page

Sealey SUPERBOOST150D Quick Start Manual page 3

6/12v 150a starter/15a automatic battery charger & maintainer

Advertisement

4.2.
HOW TO CONNECT
4.2.1.
The charger's output leads have colour-coded battery clips (RED-POSITIVE and BLACK-NEGATIVE). Determine which post of battery
is grounded (connected) to the chassis.
4.3.
OPERATING INSTRUCTIONS: CHARGING BATTERY IN VEHICLE
4.3.1.
If negative post is grounded to chassis (as in most vehicles):
Connect the red clamp to the battery's positive pole.
Connect the black clamp to the vehicle chassis remote from the fuel pipe and the battery.
Connect the charger to mains supply.
If positive post is grounded to the chassis:
4.3.2.
Connect the black clamp to the battery's negative pole.
Connect the red clamp to the vehicle chassis remote from the fuel pipe and the battery.
Connect the charger to mains supply.
4.3.3.
When disconnecting charger, first disconnect from mains supply, remove clamp from vehicle chassis, and then remove clamp from the
battery terminal.
DO NOT charge the battery whilst engine is running.
8
4.4.
CHARGING
STEP 1: Connect the battery and mains
supply. The display shows the battery's
voltage.
STEP 4: Press "SELECT" button
To select battery type
(STD / AGM / GEL) (orange light).
Note: During charging, the display defaults to show voltage. Press "DISPLAY" button, switching "V" to "A" or "%" to show charging
current or battery charged percentage.
• V = charging voltage • A = charging current • % = battery charge condition
4.4.1.
To stop charging, disconnect mains plug or remove clamp from battery terminal.
© Jack Sealey Limited
STEP 2: Press "MODE" button
To select charging voltage (6V/12V)
(orange light, except 12V START).
STEP 5: The charger starts to charge the battery automatically and the
"Charge" light turns orange. When the battery is fully charged
the "Full" light turns green.
Original Language Version
STEP 3: Press "CURRENT" button
to select "Slow" or "Fast" charging
current ("Slow"-green light, "Fast"-
red light) (6V/2A,12V 2A/15A). If
you choose 12V LiFePO4 in STEP
2, the default current will be "Fast".
You don't need to select charging
current and battery type.
SUPERBOOST150D Issue 2 (3)
12/12/22

Advertisement

loading