Huawei LUNA2000-100KTL-M1 User Manual page 73

LUNA2000-100KTL-M1 Smart Power Control System
User Manual
No. Category
46
47 Output
impedance
enhancement
48
49 Microgrid
compatibility
50 CAN build-out
resistor
51 Working mode
52
53
54
Issue 02 (2023-01-10)
Parameter Description
Delay of Delay from the time when
underfrequency- the underfrequency-caused
caused power power raising function is
raising triggered to the time when
the function takes effect
Output After Output impedance
impedance enhancement is enabled, you
enhancement can set Frequency to which
output impedance
enhancement applies to
increase the output
impedance at this frequency.
Frequency to Specifies the frequency to
which output which output impedance
impedance enhancement applies.
enhancement
applies
Microgrid When Microgrid
compatibility compatibility is set to
Enable, the inverter
(including the grid-connected
current source PCS) supports
a higher ratio of PV to energy
storage in addition to the
original grid code feature of
the country.
CAN build-out Specifies the termination
resistor resistors to be connected at
both ends of the CAN bus.
PQ Specifies the PQ working
mode in the grid-tied
scenario.
VSG Specifies the VSG working
mode in the off-grid scenario.
Per unit Specifies the resistance per
armature unit value for armature
resistance (%) windings of the virtual
synchronous generator.
Per unit Specifies the inductive
armature reactance per unit value for
inductive armature windings of the
reactance (%) virtual synchronous generator.
Copyright © Huawei Technologies Co., Ltd.
6 Power-On Commissioning
Remarks
-
This parameter is
displayed when
Output impedance
enhancement is set
to Enable.
-
-
-
-
This parameter is
displayed when
Working mode is
set to VSG.
67