Download Print this page

Thor Kitchen TEC30 Instructions

Hide thumbs Also See for TEC30:

INSTRUCTIONS FOR BUILT-IN

Cut out the work surface according to the sizes shown in the following drawing.

• Note: Before carving, check that the dimensions indicated correspond to the

dimensions of the product.

• Be sure the thickness of the work surface is at least 1.18inch. Choose a heat-resistant

work surface material.

• The safety distance between the sides of the cooktop and the inner surfaces of the

worktop must be at least 0.12inch.

• For the purposes of installation and use, at least 0.2inch space must be kept around

the cut-out.

Table of Contents

Do you have a question about the TEC30 and is the answer not in the manual?

Page 1 INSTRUCTIONS FOR BUILT-IN Cut out the work surface according to the sizes shown in the following drawing. • Note: Before carving, check that the dimensions indicated correspond to the dimensions of the product. • Be sure the thickness of the work surface is at least 1.18inch. Choose a heat-resistant work surface material.
Page 2 VENTILATION AND SAFETY DISTANCES Make absolutely sure that the following conditions are met for adequate ventilation of the cooktop and that the supply and exhaust air is not blocked: • Note: The safety distance between the cooktop and the cabinet or the cooker hood should be at least 29.93inch •...
Page 3 INSTALLING THE COOKTOP The cooktop must connect to a separate, grounded wire, single phase, AC Only electrical supply with their own circuit breaker. These appliances must be installed in accordance with National Electrical Codes, as well as all state, municipal and local codes.

Tec36