HANDLE ASSEMBLY Remove the handle from the bag Remove the 2 screws from the small bag Install the handle onto the top of the vacuum head Insert the 2 screws into the holes in the handle Using a Phillips screwdriver, tighten the screws. Do not over tighten the screws.
Page 15
Exploded drawing part list Part No. Part Description WD300 Handle Assy. WD337 Upper Cover WD338 Switch WD339 Middle Cover WD340 Motor WD341 Motor Foam WD332 Seal WD342 Seal Ring WD343 Lower Cover WD344 Tray WD345 Cable Clamp WD346 Cord WD347 Cable WD348 Cable...