Related Manuals for Jetting V0 HD 18 V
Summary of Contents for Jetting V0 HD 18 V
- Page 1 V0 HD Product model/type: V0 HD 18 V V0 HD 18 V USER’S GUIDE AND SAFETY MANUAL D A R E T O D O I T D I F F E R E N T L Y .
- Page 2 For permission requests, write to the publisher, addressed “Attention: Permissions Coordinator” at the address below. Jetting AB, Murgatan 1, 522 30 Tidaholm, Sweden jetting.se info@jetting.se...
- Page 3 fibre blower. Observe all safety information on this page and note specific safety requirements as explained by procedures in this manual. Failure to follow these instructions could result in serious personal injury or death. Caution: Noise will exceed 70 db Manufacturer Jetting AB Murgatan 1 522 30 Tidaholm Sweden jetting.se info@jetting.se...
-
Page 4: Table Of Contents
Table of contents Section Page General information Technical information Safe operating practices Unpacking the box Set up the blower Display functions Crash test Blower operations Maintenance Troubleshooting guide Documentation and disposal EC Declaration of Conformity D A R E T O D O I T D I F F E R E N T L Y . -
Page 5: General Information 1
Jetting AB is not responsible for injuries incurred as a result of improper use of the V0 HD. D A R E T O D O I T D I F F E R E N T L Y . -
Page 6: Technical Information
2. Technical information A. Condition of use Temperature from -15° C to +40° C Humidity from 20 % to 90 % Weather conditions relevant to working conditions Natural and/or artificial lighting of the work site, >200 lux B. Air compressor requirements Pneumatic pressure 16 bar maximum Required air flow... -
Page 7: Safe Operating Practices
3. Safe operating practices Read and understand all procedures and safety instructions before using the V0 HD. Observe all safety information on this page and note specific safety requirements as explained by procedures called out in this manual. Failure to follow these instructions could result in serious personal injury, property damage or death. -
Page 8: Unpacking The Box
• Never expose the charger to rain, moisture or damp. If you suspect any of thes have occurred then do not use the charger. • Only charge your battery using the compatible Jetting charger provided with your battery. Never discharge your battery other than in normal use on the V0. -
Page 9: Set Up The Blower
5. Set up the blower This manual contains setup and operating instructions for the V0 HD. Do not connect power supply until setup is complete. A. Determine fiber size • Determine fiber size to be installed. B. Select fiber seal and pipe clamp •... -
Page 10: Display Functions
IMPORTANT For the Crash Test to work properly, use the same size fiber and pipe that will be used for the job. Jetting cannot be responsible for any fiber damages. Crash Test: For all types of fibers > 0,5 mm diameter The pushing force is adjusted by pressing the Menu button and set with + and –... -
Page 11: Blower Operations
Insert the fiber and seal inside the pipe clamp as it would be for the actual installation. Install a 1 to 2 m test length of pipe into the V0 HD clamp and insert clamp into the air block. Block the end of the test length of pipe. Tighten the wheel pressure on to the fiber with the wheel drive engaged in the forward direction until the fiber starts to install. - Page 12 6. Wheel drive engages forward The wheel drive engages forward by the + button. By the – button the drive wheel will reverse. Please note that the fiber protection system is disabled in reverse drive. Please observe: Set pushing force is reached by 40 % "speed/force %". 7.
-
Page 13: Maintenance
9. Maintenance Procedure Daily Weekly Monthly 60 days 90 days Clean all assemblies and components thoroughly with dry cloth If used in moisture weather. Remove the machine from the transport box and leave it to dry completely Check/charge batteries in original charger Inspect fasteners and screws Check wheels for wear. -
Page 14: Troubleshooting Guide
+46 502-65 90 10, info@jetting.se. Documentation feedback Comments to our product documentation can be sent to info@jetting.se. We appreciate your comments. Disposal Please follow the regulations for your country regarding how to recycle parts and dispose products. -
Page 15: Ec Declaration Of Conformity
12. EC Declaration of Conformity Håkan Johan on D A R E T O D O I T D I F F E R E N T L Y . - Page 16 D A R E T O D O I T D I F F E R E N T L Y . V0 HD 18 V USER'S GUIDE AND SAFETY MANUAL...