Setting The Alarms; Disabling An Alarm; Enabling An Alarm - Oregon Scientific WR102 Instruction Manual

SETTING THE ALARMS

The WR102 has two alarms (alarm 1 and alarm 2). They can be
used together or independently. Alarm icons [
only when alarm 1 or alarm 2 are active. No icon(s) indicates that
the alarm(s) have not been set.
REMEMBER: From the Clock-Display Mode, press [MODE] to enter the calendar display and then
Setting the Alarm:
1.With the clock displayed, press [MODE] until alarm-1 display or alarm-2display is entered.
NOTE: The last set time of the alarm will be displayed. If you have never set the alarm before, or if
the alarm has been disabled, the time will be displayed as [ ------ ].
REMEMBER: At any stage of the setting sequence, if no entry is made after 9-seconds, the unit will
2. Press [MODE] for two (2) seconds; the WR102 will beep once when press is initiated and then again
after the two seconds.
3.To enter the hour, press [UP VOLUME] or [DOWN VOLUME] until the desired hour and AM/PM
designation has been selected.
4.When the desired hour is reached, press [MODE] to advance to selecting the minutes. Press [UP
VOLUME] or [DOWN VOLUME] to selection the minutes.
5.After selecting the minutes, press [MODE] or wait 9-seconds to exit the Alarm-Setting Mode and return to
the clock display mode. The alarm icon [
alarm is now set and will sound at the selected time.
When an alarm goes off, it will sound for 1-minute. For the first 10 seconds of the alarm sounding, the EL
backlight will also activate.
Alarm 1 and alarm 2 are identified by different sounds: Alarm 1 has two short bursts of sound followed by a
pause which then repeats. Alarm 2 has four short bursts of sound followed by a pause which then repetrs.
Unless disabled, the alarms will sound for a total of one minute before automatically turning off.

DISABLING AN ALARM

The alarms are easily disabled. When disabled, the respective alarm icon will not be displayed. A disabled
alarm display is indicated by blanks [ ------ ].
Press [MODE] to enter alarm-1 or alarm-2 display followed by [UP VOLUME] or [DOWN VOLUME].
NOTE: When an alarm is activated, the alarm time will be displayed in the respective alarm display.
Also, in the clock display mode, the respective alarm-on icon will appear indicating that
alarm-1 or alarm-2 (or both) is set.

ENABLING AN ALARM

When disabled, the respective alarm icon will not be displayed. The display will show blanks [ ------ ].
Press [MODE] to enter alarm-1 or alarm-2 display followed by [UP VOLUME] or [DOWN VOLUME]. The
respective alarm-on icon appear and the blank [ ------ ] alarm time will be replaced with the last previously-
set alarm time.
NOTE: To change the alarm time follow the procedure set out in the section "Setting the Alarm".
again to set Alarm 1. Press [MODE] once more to set Alarm 2.
automatically return to the Clock-Display Mode.
] are displayed
] , for the alarm chosen, will be displayed to indicate that