Page 1
LANEGARD3 ™ FOLDING TYPE III BARRICADE ASSEMBLY INSTRUCTIONS FHWA LETTER: Letter: WZ-336 Tested to Manual for Assessing Safety Hardware (MASH) Test Level: 3 CONTACT: Call 800.662.6338 to talk to a Customer Service Representative. HOURS: 8 AM to 5 PM (E.T.)
Page 2
(Enlarged to show detail) Anti-Skid Feet - Quantity 4 Pallet Nut - Quantity 12 (Enlarged to show detail) (Enlarged to show detail) 1/4-20 x 1.5” Hex-Bolts - Quantity 4 (Enlarged to show detail) *Visit PSS-Innovations.com to view retroreflective sheeting options LaneGard3 Assembly Instructions...
Page 3
Lay out Upright Assembly (3), Cross-Bars (2), and Rubber Feet (4), on a flat, clean surface. Attach optional Rubber Feet (2 per cross-bar) prior to assembly. Slide the Rubber feet onto the Cross-Bars so that the bolt hole is accessible. LaneGard3 Assembly Instructions...
Page 4
(4) outward onto the Upright Assembly (3). Be sure that the feet can still maintain full contact with the ground and are far enough out to maximize stability. STEP 3 Repeat steps 1-2 on the three other crossbar connection points on the Upright Assembly (3). LaneGard3 Assembly Instructions...
Page 5
2” bolts (8). Insert hex head bolt and washer through Upright and centerboard into the Pallet Nut. Repeat for the remaining boards. Keep Pallet Nut from turning by using the 1/4” hex key. Tighten bolts with rachet until snug. LaneGard3 Assembly Instructions...
Page 6
This disengagues the legs’ mechanical locking mechanism and enables the leg to fold. Failure to flex the legs inward may result in damage to LaneGard3. LaneGard3 Assembly Instructions...
Need help?
Do you have a question about the LANEGARD3 and is the answer not in the manual?
Questions and answers