Oregon Scientific DCA6808 Instruction Manual page 10

7
f) Delete the Last Photo
To delete the last photo you shot, press the "MODE button"
until the "Status LCD" displays
Press the "Shutter Release button" to delete the last shot.
Repeat these two steps to individually delete your photos.
g) Resolution
This camera lets you take both high (640 X 480 pixels) and low
(320 X 240 pixels) resolution photos. High resolution photos
are better quality because they have more pixels. Low
resolution photos have fewer pixels but you can take a lot more
photos in low resolution mode. The number of photos your
camera can take depends on both the resolution and the
compression you choose. Please refer to the chart below
(Fig. A) to select the correct resolution and compression for
the number of photos you want to take.
Fig. A
RESOLUTION COMPRESSION NUMBER OF PHOTOS
Hi
Lo
Note: Since the "Status LCD" can only display two digits, it will show "99"
for any mode settings that let you take 104 or 208 pictures. The "Status
LCD" will continue to show "99" while you take pictures and the camera
will store all your pictures but will not be able to display the remaining shots
available until you have reached 99.
During mode selection, "Hi" stands for high resolution and "Lo"
stands for low resolution.
To switch between high and low resolution, press the "MODE
button" until the "Status LCD" displays either "Lo" or "Hi". (See
Fig. (16)). If it is set on "Hi", press the "Shutter Release button"
to switch to "Lo". If it is set on "Lo", press the "Shutter Release
button" to switch to "Hi".
.
Hd 52
Ld 26
Hd 208
Ld 104