Table of Contents
Advertisement
Fig. L
5. Operation
The heater should only be operated through an
electronic thermostat/control device that meets the
Ecodesign directive requirements. Please contact Space-
Ray for further details.
Radiant
Heat
Control
Panel
Device
Fig. M
Radiant
Radiant
Heat
Panel
Fig. N
Fig. M illustrates how a heating panel should be wired. A
double pole switch/isolator must always be fitted along
with a time and temperature control.
Where multiple heat panels are being used, each addi-
tional Panel is wired as shown in Fig. N. Care must be
taken to ensure that the total load of all heaters connect-
ed do not exceed the capability of the time and tempera-
ture controller as well as the double pole switch/isolator.
5.1 Safety
The heater is fitted with a thermal cut-off switch which
will cut off the heater output if it exceeds its output limit
and switch it back on when it's cooled to a sufficient
level.
6. Maintenance
The Panel range of heaters contain no serviceable parts.
Double
Pole
Switch
240V Mains
Power Supply
Radiant
Heat
Heat
Panel
Panel
6.1 Cleaning
Before cleaning the heater disconnect/switch off from the
mains power supply and ensure the appliance is cool.
The heater should be wiped with a soft damp cloth and
dried. Do not use abrasive cleaning products or polishes
as these can damage the finish of the heater.
7. Recycling information
The use of this symbol indicates that this
product may not be treated as household
waste. By ensuring this product is disposed
of correctly, you will help prevent potential
negative consequences for the environment
and human health, which could otherwise
be caused by inappropriate waste handling of this
product.
For more detailed information about recycling of this
product, please contact your local council or your
household waste disposal service.
7
Advertisement
Table of Contents
