Advertisement
NOTE: Do not overtighten the hardware when installing
the snow clean-out tool mount (item 2). Overtightening
will crack the mount.
NOTE: Install the hardware so the nylon lock nut is on
the inside of the auger housing.
4. Install the snow clean-out tool mount (item 2) on the
auger housing with two 10-24 x 1/2 round head
slotted machine screws (item 4) and two 10-24
nylon lock nuts (item 3) as shown in Figure 3.
2
3, 4
Figure 3
5. Snap the snow clean-out tool (item 1) into the snow
clean-out tool mount (item 2) for storage.
2
1
Figure 4
6. Reconnect spark plug wire to spark plug.
00361400A 8/09
OPERATION
WARNING: Hand contact with the rotating
impeller is the most common cause of injury
associated with snow throwers. Never use your
hand to clean out the discharge chute.
To clear the chute:
1. Shut off the engine.
2. Wait 10 seconds to be sure impeller blades have
stopped rotating.
3, 4
3. Remove the snow clean-out tool (item 1) from the
snow clean-out tool mount (item 2) and use it to
remove the clog.
4. Replace the snow clean-out tool (item 1) on the
snow clean-out tool mount (item 2).
Page 2 of 2
Advertisement
