Ariens 72407100 Instruction Sheet

Instruction Sheet
Kit Number: 72407100, 72408100
SNOW CLEAN-OUT TOOL KIT
WARNING: FAILURE TO FOLLOW
INSTRUCTIONS could result in personal injury
and/or damage to unit.
Read, understand, and follow all safety
practices in Owner/Operator Manual before
beginning.
ACCIDENTAL ENGINE START UP can cause
death or serious injury. ALWAYS stop engine,
remove key, wait for moving parts to stop, and
remove wire from spark plug before adjusting
or servicing.
Package Contents
Check the contents of your kit for the parts listed below
(Figure 1):
Item Part No. Qty Description
1. 00170200
03901400
2. 00170300
3. 06536000
4. 06117600
4
3
© Copyright 2009 • Ariens Company • Brillion, WI 54110-1072
1 Snow Clean-Out Tool
(724071)
Snow Clean-Out Tool w/
1
Brush (724081)
1 Snow Clean-Out Tool Mount
2 10-24 Nylon Lock Nut with
Insert
2 10-24 x 1/2 Round Head
Slotted Machine Screw
1 (724081)
1 (724071)
2
Figure 1
TOOLS NEEDED
3/8" Wrench
Slotted Screwdriver
3/16" Drill Bit
INSTALLATION
1. Stop engine, wait for all moving parts to stop and
hot parts to cool. Disconnect spark plug wire from
spark plug.
2. Use the snow clean-out tool mount (item 2) as a
template to lay out two mounting holes on the top of
the auger housing. See Figure 2.
NOTE: Choose a location on the auger housing that will
not interfere with the operation of the unit and that will
prevent the snow clean-out tool (item 1) from hanging
over the sides or over the front of the auger housing.
2
Figure 2
3. Drill the two 3/16" mounting holes through the
auger housing.
00361400A 8/09 Page 1 of 2