Advertisement
2. Switch on the second NAXOS Loudspeaker and set the BT/AUX level to minimum.
3. Long press the Pair button on the second Loudspeaker for 2 seconds, the Pair blue LED should
begin to flash rapidly.
flash rapidly.
Loudspeakers should remain lit constantly to indicate a successful TWS connection. The Pair blue
LED of the second speaker should no longer be lit.
6. Ensure that your host Bluetooth device is playing music and that its volume is not set to
minimum.
7. When slowly increasing the level of the BT/AUX control of the Loudspeakers you should hear
music from them both. The volume of both speakers can be controlled by your host device.
Your NAXOS Series Loudspeaker incorporates a DSP (Digital Signal Processing) system
which has 4 preset modes of equalisation (tone control) to suit your intended mode of operation.
Pressing the Curve button on the DSP Parameter Control area of the panel will scroll through the
available modes as follows:-
The Bass and Treble controls are provided for additional adjustment of the equalisation where
required and are effective using all inputs of the speaker. The Line Out XLR connection is not
affected by the Bass and Treble settings.
Note: When increasing the desired volume level, it is possible to reach an overload situation
sooner as a result of a higher Bass setting or excessive bass content in music. This can be
improved by reducing the Bass level control of your NAXOS Loudspeaker.
NAXOS Loudspeakers can be linked together by connecting the LINE OUT of one
Advertisement
