Table of Contents
Advertisement
CONNECTING THE EQ TO THE SYSTEM
C
ONNECTING THE
The 30 Series equalizers have balanced inputs and outputs that can be used with any line-level device.
For more specific information about cabling possibilities, please refer to I
(pg. 9).
To connect the equalizer to the system, refer to the following steps:
Turn off all equipment before making any connections.
Mount equalizer in rack mount.
Install the EQs in a rack with the rack screws provided. It can be mounted above or below any-
thing that does not generate excessive heat. Ambient temperatures should not exceed 113° F
(45°C) when equipment is in use. Although the units chassis are shielded against radio frequen-
cy and electromagnetic interference, extremely high fields of RF and EMI should also be avoided.
Make audio connections via XLR, barrier strip or TRS jacks (according to application
needs)
All three types of connectors for the inputs and outputs can be used for balanced or unbalanced
connections. The use of more than one connector at a time for the input/output pair could unbal-
ance balanced lines, cause phase cancellation, short a conductor to ground, or cause damage to
the other equipment connected to the equalizer.
Select the operating range with the BOOST/CUT RANGE SELECTION SWITCH
Apply power to the equalizer
Connect the the AC power cord to the AC power receptacle on the back of the equalizer. Route
the A.C. power cord to a convenient power outlet away from audio lines. The unit may be turned
on and off from the front panel power switch or a master equipment power switch. Since they
draw a relatively small amount of current during idle, the units may be left on continuously.
EQ
S
TO THE
YSTEM
®
PROFESSIONAL PRODUCTS
C
NSTALLATION
ONSIDERATIONS
Advertisement
Table of Contents
