Heated Drain Pan Installation (Previous Design) - True SPEC Series Installation Manual

Cabinet Setup (cont.)

Heated Drain Pan Installation (Previous Design)

STR/STA/STG1D
Required Tools
• 1/4" Hex Head Driver.
• Socket Set
• 3/4" Socket
• Drill
Before you begin
Uncrate the cabinet as described on page 5. Install castors (see
"Installing 6" Leveling Legs or Castors" page 6) and level the cabinet
(see "Leveling" page 7).
1. Locate the heated drain pan (HDP) and the associated bracket
and hardware. See figs. 1 and 2.
2. With the provided hardware, install the HDP bracket on the
underside of the cabinet. See fig.
3. Position the HDP in the bracket. See fig. 4.
4. Connect the barbed 90° fittings and copper fittings to the
provided hoses. Then position the hose ends with the copper
fittings in the drain pan and connect the barbed fittings to the
hoses on the back of the cabinet. See figs. 5 and 6.
5. Connect the HDP power cord to the female connector on the
back of the cabinet. See fig. 7.
Page 14 of 24
SPEC SERIES
Fig. 1. Locate the box with the heated
drain pan (HDP) and its components.
Fig. 3. Secure the HDP bracket to the underside of the cabinet.
Fig. 4. Place the HDP in the HDP bracket.
Fig. 5. Connect the provided fittings to
the provided hoses.
Fig. 7. Electrical connection for the HDP.
03/2/2023
www.truemfg.com
Fig. 2. HDP and HDP bracket.
Fig. 6. Connect the barbed fitting to
the hoses on the cabinet.
P#991338 TEC_TM_141 | REV. B | EN