True SPEC Series Installation Manual page 13

Cabinet Setup (cont.)
Shelf Standard Installation (Kit #4)
1. With the provided hardware, secure the shelf standards to the
cabinet side walls. Hook the shelf clips into the shelf standards.
See fig. 1.
2. Push up on the bottom of the clip. See fig. 2.
NOTE: You may need to squeeze or twist the bottom of the
shelf clip for proper installation. Position all four shelf clips
equal in distance from the floor for flat shelves.
3. Ensure the shelf clip is not loose or able to wiggle out of the
shelf standard. See figs. 3 and 4.
4. Place the shelves on the shelf clips with the cross support bars
facing down.
NOTE: Be sure all shelf corners are properly seated.
Installation Tips
• Install all the shelf clips before installing any shelves.
• Start at the bottom shelf and work your way up.
• Always lay the back of each shelf down on the rear clips before
the front.
WARNING – DO NOT use pliers or
any crimping tools when installing
shelf clips. Altering shelf clips in any
way can lead to shelving instability.
TEC_TM_141 | REV. B | EN
SPEC SERIES
Fig. 1. Installing top tab of shelf clip.
Fig. 3.
You may need to squeeze or twist
the bottom of the shelf clip to install.
Shelf
Shelf
Clip
03/2/2023
www.truemfg.com
Fig. 2. The bottom tab of the shelf clip
will fit tightly
Fig. 4.
Installed shelf clip.
Shelf
Standards
Shelf
Page 13 of 24