Controlling Other Components; Preprogrammed Remote Control Codes; Entering Remote Control Codes - Onkyo TX-SR606 Instruction Manual

Controlling Other Components

You can control your DVD player, CD player, and other
components with the AV receiver's remote controller.
To control another component, you must first enter that
component's remote control code to a REMOTE MODE
button.
This section explains how to enter remote control codes
and how to control your other components.
Preprogrammed Remote Control
Codes
The following REMOTE MODE buttons are prepro-
grammed with remote control codes for controlling the
components listed. You do not need to enter a remote
control code to control these components.
For details on controlling these components, see the
pages indicated.
Onkyo DVD player (page 90)
Onkyo CD player (page 93)
Onkyo cassette recorder with

Entering Remote Control Codes

You'll need to enter a code for each component that you
want to control.
Remote
indicator
REMOTE
MODE
Number
buttons
1
2
(page 95)
(3 seconds)
DISPLAY
3
Note:
• The remote control codes provided are correct at the
time of printing but subject to change.
Look up the component's remote
control code in the separate
Remote Control Codes list.
The codes are organized by category.
While holding down the REMOTE
MODE button to which you want
to enter a code, press and hold
down the [DISPLAY] button until
the Remote indicator lights up
(about 3 seconds).
Note:
• Remote control codes cannot be
entered for the [RECEIVER] and
[ZONE 2] REMOTE MODE but-
tons.
• Only TV remote control codes can be
entered for the [TV] REMOTE
MODE button.
• Apart from the [RECEIVER], [TV],
and [ZONE 2] REMOTE MODE
buttons, remote control codes from
any category can be entered for the
REMOTE MODE buttons. However,
these buttons also work as input
selector buttons (page 47), so choose
a REMOTE MODE button that cor-
responds with the input to which you
connect your component. For exam-
ple, if you connect your CD player to
the CD input, choose the [CD]
REMOTE MODE button when
entering its remote control code.
Within 30 seconds, use the num-
ber buttons to enter the 5-digit
remote control code.
The Remote indicator flashes twice.
If the remote control code is not entered
successfully, the Remote indicator will
flash once slowly.
87